ESP8266 (CH340)
- Install driver CH341SER_win.zip
- Connect NodeMcu and check com port -> Control Panel >> Device Manager >> Ports
- Open flash_download_tools_v3.6.8.exe -> for me was ESP8266
- Put the same settings as in picture (BAUD, FLASH-SIZE, etc):
- Open Arduino IDE -> Tools >> Serial Monitor and select Both NL&CR and 115200 as picture below:
- Press 'RST' switch on NodeMcu and in serial monitor:
set ssid 'xxxx'
(in windows to show SSID in terminalnetsh wlan show profiles
)set password 'xxxx'
set ap_ssid 'xxxx'
set ap_password 'xxxx'
(min 8 characters)set ap_open 0
save
quit
Please note:
- Replace 'xxxx' with your own credential and without quotes
- During settings add '%20' if ssid contains spaces i.e. 'My Repeater' will be 'My%20Repeater'
- In case of issue → erase & upload stock firmware (bin folder, guide in References/Codes) *