Board: TelosB

Jump to bottom Edit New page

Oleg Hahm edited this page May 26, 2014 · 2 revisions

MCU

MCU	TI MSP430F1611
Family	MSP430
Vendor	Texas Instruments
Package	64 QFN
RAM	10Kb
Flash	48Kb
Frequency	8MHz
FPU	no
Timers	2 (2x 16bit)
ADCs	1x 8 channel 12-bit
UARTs	2
SPIs	2
I2Cs	1
Vcc	2.0V - 3.6V
Datasheet / Reference Manual	Datasheet
User Guide	User Guide

Radio

RF Chip	Texas Instruments® CC2420
Frequency Band	2.4GHz ~ 2.485GHz
Standard compliance	IEEE 802.15.4 compliant
Receive Sensitivity	-95dBm typ
Transfer Rate	250Kbps
RF Power	-25dBm ~ 0dBm
Range	~~120m(outdoor), 20~~30m(indoor)
Current Draw	RX: 18.8mA TX: 17.4mA Sleep mode: 1uA
RF Power Supply	2.1V ~ 3.6V
Antenna	Dipole Antenna / PCB Antenna
Datasheet	Datasheet

Flashing RIOT

Flashing RIOT on the TelosB is quite straight forward, just connect your board using the USB connector to your host computer and type:

make flash

This should take care of everything!

Using the shell

The shell is using the UART interface of the TelosB at 115200 baud.

More information

RIOT - The friendly Operating System for the Internet of Things

Homepage | [GitHub] (https://github.com/RIOT-OS/) | Developers Mailing List | Users Mailing List | Twitter @RIOT_OS