Fix etcd configuration file paths in ha-setup-apt.md (#510) (#513)

fix: Update etcd configuration file path in ha-setup-apt.md

Previously, the etcd configuration file path was set to "/pg_ha/config/etcd.conf," which is incorrect. This commit addresses the issue by updating the path to the correct location: "/etc/default/etcd."

Additionally, a missing double quote has been added to a line in the file.

Before:
cluster_1

After:
"cluster_1"

This change improves the accuracy and completeness of the configuration in ha-setup-apt.md.

Co-authored-by: mohammad <[email protected]>

docs/solutions/ha-setup-apt.md

@@ -172,7 +172,7 @@ The `etcd` cluster is first started in one node and then the subsequent nodes ar
     ETCD_LISTEN_PEER_URLS="http://${NODE_IP}:2380"
     ETCD_LISTEN_CLIENT_URLS="http://${NODE_IP}:2379,http://localhost:2379"
     ETCD_ADVERTISE_CLIENT_URLS="http://${NODE_IP}:2379"
-    " | sudo tee -a /pg_ha/config/etcd.conf 
+    " | sudo tee -a /etc/default/etcd
     ```
 
 4. Start the `etcd` service to apply the changes on `node1`.
@@ -233,7 +233,7 @@ The `etcd` cluster is first started in one node and then the subsequent nodes ar
     ETCD_LISTEN_PEER_URLS="http://${NODE_IP}:2380"
     ETCD_LISTEN_CLIENT_URLS="http://${NODE_IP}:2379,http://localhost:2379"
     ETCD_ADVERTISE_CLIENT_URLS="http://${NODE_IP}:2379"
-    " | sudo tee -a /pg_ha/config/etcd.conf
+    " | sudo tee -a /etc/default/etcd
     ```
 
 3. Start the `etcd` service to apply the changes on `node2`:
@@ -266,7 +266,7 @@ The `etcd` cluster is first started in one node and then the subsequent nodes ar
     ETCD_LISTEN_PEER_URLS="http://${NODE_IP}:2380"
     ETCD_LISTEN_CLIENT_URLS="http://${NODE_IP}:2379,http://localhost:2379"
     ETCD_ADVERTISE_CLIENT_URLS="http://${NODE_IP}:2379"
-    " | sudo tee -a /pg_ha/config/etcd.conf
+    " | sudo tee -a /etc/default/etcd
     ```  
 
 4. Start the `etcd` service on `node3`:
@@ -322,7 +322,7 @@ Run the following commands on all nodes. You can do this in parallel:
 
        ```bash
        NAMESPACE="percona_lab"
-       SCOPE="cluster_1
+       SCOPE="cluster_1"
        ```
 
 2. Create the `/etc/patroni/patroni.yml` configuration file. The file holds the default configuration values for a PostgreSQL cluster and will reflect the current cluster setup. Add the following configuration for `node1`:
@@ -598,4 +598,4 @@ HAProxy is capable of routing write requests to the primary node and read reques
 
 ## Next steps
 
-[Configure pgBackRest](pgbackrest.md){.md-button}
+[Configure pgBackRest](pgbackrest.md){.md-button}