The TX/RX-switch is a tool for signal sensitive or PTT switching for HAM radios incl. pcb schematics.
This is still "work-in-progress (WIP)" so I do NOT take any kind of responsibility for damages/data losses!
You can use this at your own risk without guarantees and put device on non conductive surface or enclosure!
If you like the new design yo are free to share it!
Have fun :)
-
USB-Cable
-
1x Custom PCB by WodoWiesel
-
3x 10 kOhm Resistors varibale
-
1x 100 nF capacitor (or without, just bridge it)
-
1x Push-Button For PTT
-
3x 2-Pin Male Pin Header
-
1x Soldering iron
-
Solder + flux + IPA
No need for that.
-
configure jumpers
-
turn on +5V power supply
-
set up LNA, Transceiver and cables
-
Have Fun 73
©️ 10/10/2023 WodoWiesel
Github (https://github.com/wodowiesel/)
Twitch (https://www.twitch.com/wodowiesel/)
Instagram (https://www.instagram.com/wodowiesel/)
YT (https://www.youtube.com/@wodowiesel/)
E-Mail ([email protected])
The new design was checked by the electrical engineer theBrutzler (https://github.com/theBrutzler/)
The new optimized PCB was designed with free KiCAD software (https://www.kicad.org/)
❗ The PCB should be produced at a manufacturer
(like PCBWay or similar) with the RoHS lead-free option for environmental protection.
- Hardware
CERN Open Hardware License Version 2 - Weakly Reciprocal
Short identifier CERN-OHL-W-2.0
- Software
This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License.