Homebridge-Envisalink-Ademco

This is a Homebridge/HOOBS plug-in leveraging a modified version of a node-red implementation ( https://www.npmjs.com/package/node-red-contrib-envisalink-ademco ) and a Homebridge envisalink DSC module ( https://www.npmjs.com/package/homebridge-envisalink )

This module was designed to work with Ademco Envisalink module with the Vista series alarm boards.

Limits:

• Ademco panels provide limited zone information to their peripherals. The panel only provide real-time information when a zone is faulted (opened) but not when it is restored (closed). However, the virtual key panel is continuously updated with zones information. This module auto set the faulted zone (opened) to restored (close) after the value set by openZoneTimeout attribute (default to 30 seconds) once the virtual panel no longer reports a fault for the specific zone.

• When system is "Armed" the panel no longer report the state of each zone. All zone will age out and be considered close once armed. Note: A bypass zone will automaticly show as fault (open) once the alarm is disarmed.

• Envisalink module only support one connection. Once this plug-in is connected, any other connections will result in an error.

Please note: As of version 1.0.8 the attribute for zones "type" attribute has been changed to "sensorType" this is to enabled the UX Hoobs configuration manager.

Configuration options

Attributes	Description
host	Envisalink server host IP Address
port	Envisalink server Port address. Default is 4025.
deviceType	Device Model
password	Envisalink server password. Default is "user".
pin	Your local alarm PIN
openZoneTimeout	(optional) Time out value for zone provided in milliseconds. Default is 30000 (30 sec).
commandTimeOut	(optional) Time out value for alarm command to return provided in milliseconds. Default is 10000 (10 sec).
partitions	List of partition to monitor in homekit
zones	(Optional) List of zones to appear and monitor in homekit

partitions

• name : partition name (default "house")

zones (Optional)

• name: zone name
• sensorType : door | leak | motion | smoke | window
• partition : sensor partition number
• zoneNumber : panel zone number for sensor

Example configuration is below.

"platforms": [

{

    "platform": "Envisalink-Ademco",
    "host": "192.168.YYY.XXX",
    "deviceType": "Honeywell Vista",
    "password": "---envisalink password (default is user)---",
    "pin": "---panel pin for disarming---",
    "partitions": [
    {
        "name": "House"
    }

    ],

    "zones": [
        {
        "name": "Front Door",
        "sensorType": "door",   
        "partition": 1
        },
        {
        "name": "Master Bedroom Window",
        "sensorType": "window",
        "partition": 1
        }
    ]
}

Non-Consecutive Zones (Recommended)

If your system has unused zones, simply include a zoneNumber integer property on each zone you have in the config. Make sure you put the property on each zone. This is the recommended configuration if you don't wish to monitor (display) all the zones within HomeKit or don't know the ordering of your system zone.

Examaple:

...

"zones": [
    {

    "name": "Front Entry",
    "sensorType": "door",
    "partition": 1,
    "zoneNumber": 9
    },
    {
    "name": "Patio Door",
    "sensorType": "door",
    "partition": 1,
    "zoneNumber": 12
    },
    {
    "name": "Garage Door",
    "sensorType": "door",
    "partition": 1,
    "zoneNumber": 5
    }
]

...