Port to f28069 launch pad #226
Open
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Initial commit of Port to F28069 LaunchPad board
Allow the modified ELS BoostXL v2 hardware to work with F280049c Launchpad
|
Is the state saving and restoring changes on power on changes required in order to support the 6X boards? Might be easier to merge if that was separated into a different PR to separate concerns a bit. @clough42 could you consider expediting this MR? There really are no 49 boards available for me right now and this looks configurable so we can choose either. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
This is a port of your original code to allow the use of the TI F28069M Launchpad as the controller. I've tried to follow your coding style for all modifications. I did have to make a small modification to your Booster Pack interface board (one pin remove from a connector and one jumper wire). This code has been running on my lathe for the past few months, so I'm confident it's stable. Hope you will consider folding it into your base release.
Obviously I'm open to any alterations you would like to see added such as different configuration options, documentation updates, etc...