Assembly Notes (Atom Board)

This page is a work in progress

Drilling the top of the enclosure

• Mount bare PCB in the enclosure and make marks through the guide holes in the centre of the three push switches. Either mark with a needle, or carefully drill through with a fine drill bit. The LEDs are exactly 15mm further out than then switches.

• Drill 4mm holes for the three switches, and 3mm holes for the the LEDs. Ideally use "lip and spur" drill bits (also called a brad point bit or dowelling bit), as these give a cleaner cut.

Assembling the PCB

Assemble in the following order

• Parts marked NF on the PCB need not be fitted
• Surface mount (Xilinx CPLD, three 0805 capacitors and SOT-23 IC)
• Visually check the CPLD for solder bridges, as these are harder to fix when the through-hole parts are mounted
• Capacitors on the underside, under the IC sockets
• Resistors
• IC Sockets
• Capacitors
• LEDs
• Pi connectors
• Headers
• Clean the board with IPA
• finally mount the switches

Configure the Pi

Basically just download and unzip the "Atom Video to HDMI Testers Release #1" from here onto a blank FAT32 formatted SD Card.

Program the CPLD

IMPORTANT: MAKE SURE YOU PROGRAM THE RIGHT FILE (!!!!)

CPLD programming instructions can be found here.

Adjust and test

Use the following program:

   10 GOSUB a
   20 FOR A=#8000 TO #81FF
   30 ?A=A
   40 NEXT
   50 LINK LL0
   60aP=#2800
   70 DIM LL10
   80[
   90:LL0
  100 JSR #FE66
  110 LDA #B002
  120 AND @#F7
  130 STA #B002
  140 LDX @9
  150 LDY @55
  160:LL1
  170 DEY
  180 BNE LL1
  190 DEX
  200 BNE LL1
  210 LDA #B002
  220 ORA @#08
  230 STA #B002
  240 JMP LL0
  250]
  260 RETURN

Finalise the Case

• file groove in case to allow reset switch to fit in (it's very tight!, add photo)