Skip to content

Section 4.4 Wiring the X Axis

Jump to bottom Edit New page
Morris Winkler edited this page Feb 28, 2016 · 11 revisions

Section 4 0025

  • Connect the Endstop cable (60cm) with the red wire close to the frame

  • Connect the Motor wire which is 53cm long.

Section 4 0024

Section 4 0022
X-Motor Connection

Section 4 0023
X-EndStop Connection

  • Lead the wires through the side opening.

  • Connect them to the RUMBA like you did with the Z and the Y.

  • This is a temporary connection, you will make it nice in a minute.

Add a custom footer

##i3 Berlin
1 Introduction
1.1: History
1.2: Tools and Parts
1.3: Preparing the Casings

2 Assembly of the Y-Unit
2.1: Rods and Power Supply
2.2: Front- and Back- Plate
2.3: Mounting Y-Carriage and Belt

3 Assembly of the XZ-Unit
3.1: Mounting the X-Axis
3.2: Mounting the Z-Axis
3.3: Mounting the Timing Belt
3.4: Assembling the Extruder

4 Wiring
4.1: Wiring the Power Supply
4.2: Wiring the Z-Unit
4.3: Wiring the Y-Unit
4.4: Wiring the X-Axis
4.5: Gluing the Endstop Magnets
4.6: Uploading Firmware
4.7: Wiring the Extruder
4.8: Mounting the Heatbed

Cable Lengths Rumba

5 Calibration
5.1: Testing Functionality
5.2: Calibrating the Y Axis
5.3: Calibrating the X Axis
5.4: Calibrating the Print Platform

6 Printing
6.1: Filament Holder
6.2: Cura
6.3: Kisslicer
6.4: Dual Printing

Clone this wiki locally