-
Notifications
You must be signed in to change notification settings - Fork 20
Section 5 Calibration
Finally we are getting the printer alive step by step. While doing this you will also calibrate your printer. Without proper calibration the printer will not function properly. Don´t worry, it will be easy.
Section 5.1: Testing if everything works and closing of the last bits of the casing.
Section 5.2: Adjusting the Y axis to be parallel.
Section 5.3: Calibrating the X-Bridge to be straight.
Section 5.4: Calibrating the Print Platform.
##i3 Berlin
1 Introduction
1.1: History
1.2: Tools and Parts
1.3: Preparing the Casings
2 Assembly of the Y-Unit
2.1: Rods and Power Supply
2.2: Front- and Back- Plate
2.3: Mounting Y-Carriage and Belt
3 Assembly of the XZ-Unit
3.1: Mounting the X-Axis
3.2: Mounting the Z-Axis
3.3: Mounting the Timing Belt
3.4: Assembling the Extruder
4 Wiring
4.1: Wiring the Power Supply
4.2: Wiring the Z-Unit
4.3: Wiring the Y-Unit
4.4: Wiring the X-Axis
4.5: Gluing the Endstop Magnets
4.6: Uploading Firmware
4.7: Wiring the Extruder
4.8: Mounting the Heatbed
5 Calibration
5.1: Testing Functionality
5.2: Calibrating the Y Axis
5.3: Calibrating the X Axis
5.4: Calibrating the Print Platform
6 Printing
6.1: Filament Holder
6.2: Cura
6.3: Kisslicer
6.4: Dual Printing